Quote:
Originally Posted by Marcbrz86
Okay looks like I'll run 245 square on 18x9 +30, just to clear somethings up when you say it'll poke .5-1 inch outside fenders is that for the rear also or just the front?
Do you think the camber from the lowering springs will give enough camber for front or should I get some crash/camber bolts for the front
Sent from my iPhone using Tapatalk
|
Both front and rear will poke. There are many factors involved and I can't give you an exact answer on how much it will poke.
Rear is about 5mm wider so it would poke less. BUT, front camber is easily added with camber bolts vs more expensive rear lca. BUT rear gains more camber than the front as it is lowered.
They will poke though. The 1.75" wider than stocks, mentioned in the previous reply is a good starting point to figure out if it will poke too much for your taste.
I would recommend camber bolts as that will allow you to have matching camber on both sides when you get an alignment. More camber up front is good for more front grip and it will lessen the appearance of poke.
Check other brands for similar wheels with different sizing... enkei raijin(good brand), miro 111/112, and xxr 530.
xxr 530 come in 18x8.75 +33 which is about 5mm further in than the 18x9 +30 ag wheels. I would suggest xxr(budget) or enkei(quality/value) over the ag's.
Also check the xxr/raijin wheel thread to get better idea on how they fit.
Good luck!