Quote:
Originally Posted by Pro60modman
How do I setup the logcfg to read actual manifold pressure and log all of the VVT parameters?
EDIT:
Figured out manifold pressure I think
paramname = MAP
paramid = 0xFFF8DB94
isfloat = 1
scalingrpn = x,.14503773773020923,*,14.7,-
|
The big issue with logging on Tactrix is knowing the ecu ram address to log for the parameters.
All the ones I know about are in first post in this thread, if you have a rom calid other than the known ones your in a bit of trouble. you could try posing on romraider site for the ram addresses.
other alternatives are use Techstream for logging, its a bit slow on refresh rate though , but you can use tactrix as the interface or buy a copy of brzedit. see here
http://www.ft86club.com/forums/showp...54&postcount=1
other option is maybe a used ecutek cable for brz/86 as you can log any brz/86 no need for licience, you only need licience to flash ecu.
..