Quote:
Originally Posted by JazzleSAURUS
It might be just me, but I think these would look awesome installed with a few rivets per side...
|
It wouldn't be terrible to drill your own holes in the carbon. Just have to be careful and start small.
Quote:
Originally Posted by pcuerpo
@ VeloxEric, one last question, if the bumper has already burnt parts, will there be any mounting issues? mine seems pretty light only but need to make sure before i make a purchase.. will try to take a pic for you to see the amount of damage if you want or need it |
As long as you clean the burnt parts and make the surface uniform with the rest of the bumper, I'd say you'll be alright. I'd sand it till it was flat-ish again and then go along with the install per the manual. Dremel, orbital sander, hand sanding would all take care of this I believe.
Thanks,
Eric