Quote:
Originally Posted by Eazy-V
I have a FBM turbo kit and it seems that the intercooler is pushing down on the black front tray/shield and causing my front bumper with Seibon lip to sag (gaps near the side markers)...anyone else have this issue?
Has anyone removed that tray/shield and whats the purpose of it?
|
I had to take mine off and cut the tray under it. The easiest way to mark where you need to cut is to just take your bumper off and use tape and go around the radiator where is touching the intercooler. Then take the shield off and cut it. I had to remove about 2 millimeters worth of material going down. I wasn't happy about it at all.
__________________
2014 Subaru BRZ
FBM Turbokit: GTX3076R - ECUTEK HRI FlexFuel tune - FBM 3" Turboback Exhaust - 550cc Injectors - Walbro 485 Fuel Pump - 4bar Map Sensor - FBM Oil Pan - ACT SB7-XTSS - AMSOIL all fluids - Forester XT Oil Cooler - Cusco engine, trans mounts - Whiteline rear differential bushings - Perrin shifter bushing - Firehawk 235/45/17 - AEM Failsafe