After several setbacks I finally got my kit installed and running. Took a cumulative 16 hours or so with a partner over the course of a couple of days. Went with a DT F&G...idles like a champ and the low speed drivability is superb. Having problems in partial throttle...the BOV is opening up and venting when I'm increasing throttle anywhere in 4th gear or higher once I'm past 4K or so. Everything pretty much goes to hell at that point. I haven't gone above 50% throttle or so but it pulls in 1st and 2nd just fine. Pretty sure I need to run a higher tension spring in the BOV...came preassembled with an 8 PSI and no others included. Looking forward to getting that worked out and the tune dialed in. The induction noise is absolutely nasty and the quality of the kit is impressive. I have some wiring from the cam angle sensor that is touching the downpipe that I need to get a loom around...and I forgot to put the foam back on the crash beam. Excited to see what the future holds!!!
