Thanks Steve nothing connected, format is FAT32. Clue is probably in the triggers (thanks!):
Code:
;-------------triggers---------------
conditionrpn = RPM,0,>
action = start
conditionrpn = RPM,0,==
action = stop
I think I did like this:
1) Switch off ignition.
2) Wait for Tactrix stop flashing (to be sure not to corrupt the log data, don't know if it's necessary? Normally you shouldn't unplug a disc being written to).
3) Start the car
directly again.
I guess starting the engine
directly again, maybe it's doesn't have time to boot up, and just never register "conditionrpn = RPM,0,>". When it finally boots, the rpm are already at idle speed.
So I should just delete those lines quoted above? If there are no triggers in the logcfg.txt, what decides when it starts to log, "power on"?
Another question, should I remove the SD card when doing ECU flashing? I do that now just to be safe side, but is it necessary?