Got the Base map yesterday, and installed all the parts. Winged the Flex-Fuel Install as the instructions on the website are for their old flex-fuel kit. Super Simple and easy, except for the fuel line tool being difficult to fit in the factory fuel line, and the Non-waterproof control box needing to be installed in the engine bay.
I wouldn't be worried, except I wash my engine bay every once and a while and the vents let in quite a bit of water. I am also looking at replacing the hood with larger vents that will compromise the location of the controller. Looking at ways to waterproof it. I may end up trying to cover the circuit board in epoxy like some of the guys do with Factory HID ballast in the retrofit community. Still have the issue of the connectors, but I will figure something out (Flex-Seal?)
Only have a picture of the injectors for now, as I was excited and forgot to get a picture of the flex-fuel kit:
Edit: Flex-Fuel Pictures
EBCS Mounting is temporary until I can lengthen the wiring harness for it.