Quote:
Originally Posted by ysu
I've got everything done; header is installed, tune is applied. Sounds very nice, goes very nice. 0-100 is down to 7.3s (AT). I like this
There's one thing bugging me; the pipe actually touches the bottom plate. What do you guys recommend, how to best address this?
|
Some owners have this issue and other don't. If there is some contact you will need to do the following:
1. Remove skid plate
2. Place block of wood on bottom of skid plate
3. Hammer the raised section until flat
This should take care of the contact. Glad to hear the install and tuning went well