Quote:
Originally Posted by johan
Those shrouds are awesome. I've wanted to do something like that on past cars I've owned. What is that rubber piping you're using to seal them off? Is it self adhesive or did you use some kind of contact cement?
|
I refer to them as sheet metal seals. They actually slip on the edge of the sheet metal and have the large nice sealing surface already on them. Very neat for finishing sheet metal work and sealing at the same time, especially when you're not good at fabricating!
Quote:
Originally Posted by zeal86
Very impressive work!
|
Thanks sir!
Quote:
Originally Posted by civicdrivr
I want to build a shroud for mine to work with the Vortech intercooler and JDL bumper bar. Might have to steal your mounting method  |
Please do! I hope it spurs more people to try their own. You could technically cut these out with sheet metal shears from scratch then bend on an edge of a table.
I wish I could do something for everyone that was nice but there are far too many variables to make an effective kit for everyone. It'd have to be turbo kit and crash beam specific.
Thanks,
Eric