@ GSpeed good feedback.
I was actually thinking that if you bounce the floor pan off a curb or something and you get a 1" dent, suddenly the seat is up higher and the harness gets way tighter, or the harness is way looser.
Interesting to hear your feedback. We considered doing this with our Lemons Fiero since it has no transmission in the way, and one of our drivers is 6'8". We figured it would allow us to lower the floor pan and reduce it's structural concerns, and box out the area. We ended up going with ultra-low seat mounts, and pushing the pan down just a bit, and shortening the pedals. I still think a caged seat mount would of been awesome.
__________________
SOLD: 2015 WRB BRZ Limited ('02 WRX BBS, S-04's, Stoptech Sport pads, MXP SP, AVO drop in filter, Mishimoto Intake tube, decatted header, OFT 93 Stage 2 EL Tune, Kartboy rear shifter bushing, Whiteline transmission and subframe lockout bushings, ST Coilovers, SPC Camber bolts w/smaller crash bolt, SPC LCA's & SPC Toe Arm bushings, Red TOMs, TRD Wing.)
|