Quote:
Originally Posted by Ultramaroon
I'm going to call it a blown end bearing on the mid-shaft. It goes away in fifth because the mid-shaft isn't loaded. The input shaft is coupled directly to the output.
This is the same problem I have. I took off the afternoon to finish my trans swap. I hope to start digging into mine this coming week.
On swapping them out and moving them around, for a 200 HP engine, this transmission seems very light, IMHO. I am amazed that the boosted folks aren't leaving trails of parts everywhere.
|
That is what I was chalking it up to. I've got a used tranny with 2k coming tomorrow so I'll get that swap done over after the long weekend (need a break before I break it).
Let me know how yours goes.
I knew boosting it would cause some increased wear but man some of this is getting out of hand.