View Single Post
Old 06-27-2016, 11:53 AM   #7
philooo
Senior Member
 
Join Date: Mar 2014
Drives: 13' Scion FRS Track car
Location: miami
Posts: 417
Thanks: 76
Thanked 107 Times in 84 Posts
Mentioned: 7 Post(s)
Tagged: 2 Thread(s)
Looking great, the design is a good improvement over the planted base:
- thinner
- recessed rear bolt location is exactly the solution that was needed to make the seat extra low

My only down is the center bridge which make lower belt setup "easier". Not the best location but at least it works for those of use who don't want to weld anchor point to the bottom of the car. Personally I prefer the sub belt to be attached to the seat rather than the chassis, as I have no idea what part of the chassis offer strong support or not.

Overall, looking great, again the low profile that's what it is all about on this car.

Forgot to mention, at $129 they are VERY attractively priced. Way to go, now if you could show some seat bracket that you recommend as well, that would help to buy a full kit. I personally struggled finding good seat brackets.
__________________
philooo is offline   Reply With Quote
The Following User Says Thank You to philooo For This Useful Post:
GSpeed (06-27-2016)