Quote:
Originally Posted by phantasticity
I'm getting the code p2096 after install headers, o2 sensor is brand new from dealer so its not that. And when the CEL is on the car runs hella weird, it starts up hella weird too, feels like it gonna shut back down, which sometimes it does. And the RPMs dropping hella weird too. Can anyone help me out?
|
If you have not touched anything else then you likely have exhaust leak causing 02 sensor to see fresh air so ecu is setting lean code
http://www.obd-codes.com/p2096
How much force did you use to install o2 sensor ?
excessive torque can damage them
is sensor screwed in all the way so ring is seated.
if it tight run a M18 by 1.5 mm pitch thread tap through header bungs
did you use new exhaust gaskets
make sure both plugged in correct sockets
grey plug is primary (first) sensor
make sure your tune is correct, running a petrol tune on e85 will cause lean condition