Quote:
Originally Posted by pgranberg11
you need to loosen the pulley bolt. I made the same mistake. the farthest pulley to your left needs to be loosened up just a little bit. you don't need to take the whole bolt off, but loosen it enough to be able to adjust the tension. then you can use the long bolt to make it tighter or looser.
basically the bolt you see on the picture to the left, that bolt needs to be loosened just the slightest bit. and you should be able to adjust.
|
Yes, the proper way to tension this was brought to my attention, but the tensioner is still backwards and maxed out. Took it in and the guys at PRE owned the mistake and flipped it so I am now running on proper tension
Sent from my iPhone using Tapatalk