Quote:
Originally Posted by Koj
nice job with that polishing ;-)
@ jackblack21
With the HKS kit, you need :
- an oil cooler
- an oil Temp jauge & Oil Pressure Jauge.
- a new Omnipower flowmeter / air flow sensor 3 bar
- bigger wheel because 215 is too short, unless you want to drift at all red light
- better brake pad & brake plate
- etc..
You can check my config is need more advice. |
2.5 bar MAP will do as well.
Torque can be set up for oil temp. Provided oil level is good and not over approx 125C you dont need a pressure gauge. Need heavier oil though. Agreed upgrade pads and fluid or just wear thru brakes quickly.
__________________
5:AD kit, HKS V1+ S/C, ECUtek dyno'd, Ohlins MP20, Magnaflow cb, Revworks UEL, Topspeed overpipe, Pinnacle Ceramic tint, VG shark fin, HID's, yellow DRL's, full LEDs, red floor lights, Homelink mirror, trunk lid liner, Perrin LWCP, Valenti smoked, Flossy Grip Tape Shorty, GT86 plaque, lighted vanity mirror, Michelin PSS, Project mU +800, DOT4 fluid, 720 Form GTF1 17x8&9, stitched leather bits, EZ valve.
Last edited by wbradley; 06-15-2016 at 11:20 PM.
|