That pinch weld was NOT bent by just jacking up the car (at least according to some "experts" on this other thread) /s
http://www.ft86club.com/forums/showt...ght=pinch+weld
Quote:
Originally Posted by justatroll
I have jacked up this car by the pinch welds and they FOLD OVER immediately.
They CANNOT support the weight of the car unless you have the "puck" device that supports on either side of the pinch.
Drive the car up on a 2X4 and then use the low profile jack to jack on the jack points identified in the manual.
I can almost guarantee that ALL of the people above that said that it is OK to jack by the pinch welds have not done it on this car
|