[syelenik]

A few tips in addition to the great advice and post above.

1. You may have to get the 12mm wrench at the nut from a weird direction/rotational position to get the open end to mesh on the nut and have room to loosen and later to tighten. When you get up there while upside down with the door sill piercing into your back it should be clear.

2. Small adjustments make a big difference.

3. The rod is tough to turn and someone mentioned putting a pair of gloves on, another suggestion is to wiggle the clutch pedal up and down and inch or so and keep wiggling it while you turn the threaded rod. Again you don't have to turn the rod much. And it turns real easy while wiggling the clutch pedal. Watch the clutch pedal position while you turn the rod and you will see it moves quick.