Quote:
Originally Posted by mav1178
Here's what it should look like overall:
|
Just took a look at the brakes, there was no way i could pull the pads out of the caliper as seen in the video. Had to press/pry pretty hard in order to pull the pads out.
Quote:
Originally Posted by ZionsWrath
I could push in OEM piston by hand. Since new have not been able to push in AP sprint pistons by hand  |
Same, with the pads out of the caliper I still was not able to press the pistons in by hand (Yes, brake reservoir cap was off)
I also noticed the front pads started to show taper wear, my rear pads are Pmu Club Racers.
Currently reading through @
ATL BRZ thread on uneven pad wear
http://www.ft86club.com/forums/showthread.php?t=84215