[fumanchu1]

Originally Posted by Teclis

I suggest people to check this out: http://www.ft86club.com/forums/showt...12#post2310412

Hopefully I can use the pressure sensor relocating kit from fastwrx (no I do not by any means have anything to to with them) http://www.fastwrx.com/products/remo...re-sending-kit

And cross my fingers for that the mishimoto housing's place for sensors are big enough for the innovate temp sensor

why don't you just get an m18x1.5 to 1/8 adapter and tap into the oil galley plug like you should?


For pressure only, you could also buy a T adapter disconnect factory sensor(green wire) and replace with the T adapter and both sensors plugged (can't also do temp here as it is not in the flow).