|
Hi folks,
I'm new to this forum but have had been reading through through this thread with great interest. Lots of really good information on here!
I have been running the cosworth SC for about 9 months now and have put about 16k miles on her . Beginning to get itchy fingers again so i have just ordered forged internals and a bunch of other good stuff.
I am going to make up a set of pulleys to speed up the SC. Does anyone have any thoughts/comments on running a secondary set of pulleys in front of the crank pulley? It would save changing all the stock pulleys and you could run a really neat short belt. As far as I can see the only thing in the way is the inlet pipe and I would think this could be re routed. I'd really appreciate some ideas on this.
Cheers in advance.
|