Quote:
Originally Posted by ZionsWrath
Prefer just something I can buy. I have no fabrication equipment or experience.
Also I drive to my events I like my cup holder ^_^ If it is easy to bolt on and off sure but if I have to remove the center to reach the back side I'd rather not.
The regulation is
Did some looking around, only premade one I see is the STM one but its from NZ...
|
I didn't realize they upped the requirement this year. That kinda sucks if you're in a street car.
The one I originally used for the Vette was a Brey-Krause unit. It bolted between the seat and slider and tucked the bottle under your calves or same spot on the passenger side depending on where you can reach.
Generally speaking, you want it somewhere you can get it while belted in, just in case.