Well...while inspecting my install I noticed my v-belt was incorrectly placed from the top on my SC pulley but not at the bottom... I fixed that but during my inspection I found that the dip stick boss I thought I cut down to 5mm was off by a couple of millimeters or so and contacting my SC pulley.
So... I'm going to release the tension on the v-belt and the bolts on the supercharger bracket then push it back and see if I can create enough space to file down the boss or use a mini hacksaw... crossing my fingers! If not, off with the bracket...
Anyone else run into this issue? I don't know why the instructions didn't require the boss to be cut/grinded down to like 2mm to be safe side.
__________________________________________
projekt zeal86 build
zeal.eightsix Facebook
Instagram | zeal.eightsix