[PeterFRS]

In need of some advice here please
my fronts are fine where they are, just wanting 1/2" lower with rears..

the rear bottom "cup" is pretty shallow in our application and it is maxed out currently.
still lots of threads left on the shock body itself I am not right up to the spring perches.

I hope I am explaining this right..
and my question is.. by me "squeezing" or compressing the springs would that result in lower height?
or by "lowering" the pre load rings essentially "releasing" spring preload result in lower height?

thank you.. lol geez reading back what i wrote it's confusing for me too.