[gtpvette]

Put the RCE Yellows and the Whiteline Camber bolts in the front yesterday. Front camber is at about -1.2ish +/- .1 (base on digital level) side to side so I went ahead and put the 3MM spacer in just in case. It's still pretty snug between the wheel and strut.


Can anyone one tell me what is a safe minimum clearance between the strut and the wheel?? And a good way to measure it?? It's hard to get in there without a lift.


I did drive the 52 miles to work this AM,,, tires are a bit noisy but otherwise it's good!