Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

Nigelr32 · 03-23-2016, 07:15 AM

Hi all,

I want to change my project car over to the bigger beefier bearings, from other Subaru models. I have looked around the 'net and have found various threads regarding doing this. All seem to be 3yrs old or older?

I see Megan do/did supply a set up which gives the 114.3 pcd, but it doesn't look like it gives the bigger bearings?

Can someone please tell me what hubs actually are a straight swap on the rear and what is closes to fit on the front. If I have to buy/make new uprights, fine, but is there anything out there that bolts straight on?

All advice will be gratefully received..

BTW. I need to keep my ABS sensors as I need them for my MoTeC to take care of TC etc.

03-23-2016, 07:15 AM	#1
Nigelr32 Senior Member Join Date: Oct 2014 Drives: '14 GT86 project, '13 GT86 DD Location: UK Posts: 249 Thanks: 99 Thanked 263 Times in 100 Posts Mentioned: 4 Post(s) Tagged: 0 Thread(s)	114.3 hubs Hi all, I want to change my project car over to the bigger beefier bearings, from other Subaru models. I have looked around the 'net and have found various threads regarding doing this. All seem to be 3yrs old or older? I see Megan do/did supply a set up which gives the 114.3 pcd, but it doesn't look like it gives the bigger bearings? Can someone please tell me what hubs actually are a straight swap on the rear and what is closes to fit on the front. If I have to buy/make new uprights, fine, but is there anything out there that bolts straight on? All advice will be gratefully received.. BTW. I need to keep my ABS sensors as I need them for my MoTeC to take care of TC etc. __________________ Nige '14 GT86, '13 GT86 Build :http://www.ft86club.com/forums/showthread.php?t=75794