Quote:
Originally Posted by vgi
congrats, c30 or c38?
is it kraftwerks' tune? you could contact them and ask about disabling dct code
|
Yup, contacted them last week. Their supposed to be sending an updated tune, haven't heard back since but, I'll touch base again.
Word of warning for install, especially in New England were the salty air corrodes the aluminum. Note: Not Kraftwerks fault. Careful with the lower bracket that bolts to the block. Had both bolts start to creak halfway through, stopped so I could remove and run a re-thread tap to clean out. Hex stripped trying to back out immediately. So, now having to drill the head of the bolt off so I can pull them. Since these holes have nothing in them previously it's easy to cake up from the corrosion. I knew better to run a re-tap before, but I was just too excited to get this on. Now I'll be waiting a week or more for the replacement bolts.