|
Finally got the reverse camera working. It was a combination of multiple issues.
First off the NTE962 voltage regulator wasn't working right (don't know if it's defective or if I'm defective, I'm going to go with the latter), so I ordered the encased pre-made one recommended from Amazon above. Now I have a 6V wire for the camera.
Second problem was the pins I had inserted into the 28 pin harness for the camera input RCA +/- were ever so slightly loose in the holes apparently, because when I jiggered around with the wires the camera input magically started working. So I bent the pins upward to create a bit of counter-pressure and then wrapped some tape around them for good measure. Good to go! Thanks guys.
|