|
Old thread back from the dead again...
My catch can has never caught much volume of oil. When I thought on occasion that I had accumulated an inch of oil in the can it was in fact just a bubble of oil filling an inch of the gauge on the can.
My intake manifold is spotless inside, indicating little or no blow by from the crankcase vent.
I recently put the supercharger back in my car, after only getting maybe 1000 kms from it before it died last year. I have put a few hundred kms on it this year on mild days. I will monitor both the can as well as the throttle body to determine how much blow by there actually is with my max 8.5 lb set up.
Based on the input of a mechanic on this thread, these cars, when properly broken in should typically allow very little blow by past the piston rings. I am sure with higher boost applications the blow by will be greater.
__________________
5:AD kit, HKS V1+ S/C, ECUtek dyno'd, Ohlins MP20, Magnaflow cb, Revworks UEL, Topspeed overpipe, Pinnacle Ceramic tint, VG shark fin, HID's, yellow DRL's, full LEDs, red floor lights, Homelink mirror, trunk lid liner, Perrin LWCP, Valenti smoked, Flossy Grip Tape Shorty, GT86 plaque, lighted vanity mirror, Michelin PSS, Project mU +800, DOT4 fluid, 720 Form GTF1 17x8&9, stitched leather bits, EZ valve.
|