02-17-2016, 10:31 PM
|
#4
|
|
Senior Member
Join Date: Jun 2013
Drives: 2023 GR SUPRA,15 FR-S (SOLD)
Location: Philadelphia, PA
Posts: 4,234
Thanks: 3,087
Thanked 2,101 Times in 1,397 Posts
Mentioned: 31 Post(s)
Tagged: 2 Thread(s)
|
Quote:
Originally Posted by Tcoat
I would just use some tube silicon to seal it all up.
 |
Quote:
Originally Posted by huynh_FRanciS
Hello everyone, I just recently install a reverse camera in my frs, and I ran into a bit of a problem. The wires don't fit in the rubber insulator that holds the wires to the trunk, so I routed the wires beside it. Now the rubber insulator doesn't fit back into the hole, and I'm scared water is going to see people inside. I've been thinking about shoving it back into the hole, taping it, and spraying plasti dip on it to keep the water out. Any suggestion on how to do it better?
|
3m Window weld or Permatex Marine Silicone Adhesive works really well for this kind of application as well
__________________
*SOLD*OFT Stage 2 UEL E85/Nameless Performance 3 inch axleback with 5 inch mufflers/ TRD CAI / CNT UEL/ Cusco Strut BAR & LHD Brake Stop / "JDM" Toyota Badges / WinJet JDM headlights - DRL MOD from fteightysix.com - 5000K Diode Dynamics HID kit / Diode Dynamics LED interior Lights and sidemarker bulbs / JDM Clear Sidemarkers / Diode Dynamics LED switchbacks/ OLM LED rear turn signals / Tap Turn Relay*SOLD*
|
|
|