I was in Ottawa this weekend for some karting and came back with another set of wheels I bought off someone on Kijiji:
They are just some cheap Dai Alloys that I bought for a set of winters that will clear my brake kit but found out that I referenced an incorrectly printed template when I bought them that made it look like I had sufficient clearance. I checked again with a proper template and it looks like the caliper might scrape slightly on the inner edge of the spokes. When I cut the template square, it just barely scrapes but when I trimmed the edges, it clears so it's hard to tell if it will actually clear. Even if they do clear, it looks like it will be uncomfortably tight unless the template is really conservative. I'll test fit these when the brake kit actually goes on but it looks like I may need a small spacer.