There are two beams that extend into the engine bay.. In the pictures, the left side seemed to have bent a little bit (you can see the tiny crease) and thats why im concerned. The front part of the unibody was hit hard and the car spun out 180 degrees. So the unibody was damaged and the insurance company is going to put it on a frame rack... This is the picture of the crease
Everything else seems ok. From what i see. The doors and trunk all line up and close perfect. But i know for a fact the beam that took the impact isnt straight anymore.. That being said... It should still be repaired properly right? It isnt impossible? Im just worried about my car being back to 100% and drive like it did before.... Any advice on frame/ unibody repair, bracing, or strengthening is welcome. Anybody with experience on this please chime in.
Sent from my LGMS345 using Tapatalk