Quote:
Originally Posted by D-VO
Hey guys. QQ for you: Where exactly does the 'GDI Firing Angle Low Load Cold' become effective? Its a little confusing. Why would there be a designation of "High Load" and "Low Load" if both tables have an X-Axis of 0.20 -> 1.20 load? Also, where does "cold" start and end? @ Td-d @ Kodename47 @ ztan Maybe?? |
A01G:
High and Low Load switch is based on a value at FFF8A060 (1=high load table). Have not been able to trace where this gets set, I was wondering if it related to A/C on or off.
Cold/Hot switch for these tables is based at FFF89F42 (1=cold table). Again, I have not traced where this gets set - a lot of the RAM switches are set based on indirect referencing and can't be looked up easily.