|
The 45 degree silicone hose that goes into the intake manifold seems to be slipping if I drive the car over 6k rpm. Saw that it slipped enough so the silicone hose from the opposite end came into contact with the pulley. The clamp also rubbed which resulted in my pulley being scraped. The belt is totally fine however...no signs of premature wear from the pulley getting scraped.
I'll be sourcing a stock pulley. If anyone can help me finding an OE pulley for the Rotrex blower, that'd be great. Also, thoughts on why the silicone hose slips off? The clamps were properly torqued down (wasn't over torqued so it wasn't damaged).
I am running on the CARB tune.
Just wanted to pick people's brains about this slipping issue. Car goes back to the shop on Tuesday to get looked at.
Thanks!
|