View Single Post
Old 12-06-2015, 10:06 PM   #62
ovel86
Junior Member
 
Join Date: Sep 2015
Drives: Toyota86 2015
Location: Melbourne
Posts: 2
Thanks: 0
Thanked 2 Times in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Send a message via Yahoo to ovel86
Hi notout86, thanks again for this great write-up! Also thanks to greencounty and everyone else who provided really good details in this. This is my DIY at the moment. Fingers crossed i get it as well as notout86 did..

Couple of questions:
1. Did you have to finally leave nothing connected to 4-pin section CN4950 where you originally had your rear camera setup?
2. From the last diagram of greencounty, the DPDT switch shows that if you switch it to the BOTTOM ON (it also powers the topmost harness that is for the reverse signal, which is also powered by switching the TOP ON. I can imagine hooking up a wire connecting the BOTTOM ON and TOP ON power, but with a diode so that only when the BOTTOM is ON the TOP is ON as well, bit not the other way around?

Thanks guys!
ovel86 is offline   Reply With Quote