We finally got the trans tunnel cover cut out and test fit. These will reduce under body drag and can be used with or without JDM under panels. It requires drilling (4) pre-existing holes 63 thou larger for rivet nuts to be installed.
Currently we will utilize spacers to drop the entire plate down lower for various exhaust fitment. If there are other ideas on how to fit various exhausts that sit significantly lower than OEM, we would like to hear these ideas out though. The more of a single design we can produce, the less the end part will be. We have confirmed mounting points which is a great start though.
We plan to coat these in a durable black powder coat like the diffusers. We also plan to continue our way further backwards and tying this into our rear diff/suspension covers if all goes well. Enjoy the pictures.
Thanks,
Eric