View Single Post
Old 11-27-2015, 04:09 AM   #27
FRS Justin
Senior Member
 
Join Date: May 2014
Drives: 2013 Asphalt FRS
Location: San Antonio
Posts: 994
Thanks: 693
Thanked 695 Times in 417 Posts
Mentioned: 22 Post(s)
Tagged: 1 Thread(s)
Quote:
Originally Posted by Toyota86.ir View Post
My Summury about FD swap with AT and MT Transmission :

most street drag is between 20-110 miles and the best choice for AT is 4.88-5.29 and best choice for MT is 4.77-4.88
my choice for AT is 4.88 and for MT is 4.72

please see below, each cell number shows the percent of time reduction.
for example the AT 4.88 number in table is 5.2 at 170km/s. number 5.2 means if AT 4.1 reach 170km/s in 17 seconds then AT 4.88 reach 170km/h in 16.11 seconds.
16.11 is 5.2% lower than 17 seconds.




see other numbers in this excel :

http://toyota86.ir/wp-content/upload...1/FD-GR-T.xlsx

this is another useful excel i downloaded from this forum and uploaded again because google link was not available:
http://toyota86.ir/wp-content/upload...86-Ratios.xlsx



In drag racing you want to run max rpm at the end of the 1/4 in 1:1 which is 5th gear. A 5.29 will not get you there unless you run a smaller tire. A drag only no street driving car would want a 5.71 ratio in 5th gear or a 4.56 max rpm in 4th gear. SO choose tire size then get the gearing
__________________
Instagram FT86PROJECT9S
Facebook FT86PROJECT9S
710whp
FRS Justin is offline   Reply With Quote
The Following User Says Thank You to FRS Justin For This Useful Post:
Toyota86.ir (12-01-2015)