Quote:
Originally Posted by toysub
Thanks for the great posts. Question on the door, did you have to tape the CCF/MLV to the panel when reinstalling? Was there any problems with fitment?
Looking forward to any updates you have on the wheel wells as I'm considering doing this since I'll be upgrading the sound system.
|
I glued the all the CCF to the MLV. I used 3M Super 90 in the beginning.. but now I use the Weldwood Landau adhesive since it's better and I have tons of it.
I only ran into a few problems on the doors.
1. For the Styrofoam insert on the doors, I didn't realize I would have a problem there. I simply cut a straight line from the bottom up about 6 inches (centered between the two clip holes) to allow it to "spread" as it got pushed inwards.
2. I also had some fitment issues where the door switch harness clips to the door frame (about 6 inches above the speaker). There are two holes there (one for the door panel and one for the wire harness). In my pics I only have one hole cut. I ended up cutting two separate holes.. but it was very tight.. so I ended up just cutting one large hole there instead of two separate holes.
3. I also noticed the wiring for the door light was way shorter on my driver door. I originally had my MLV/CCF mirrored right and left, but I had to cut a different slot on the left door.
4. I cut about another inch off the entire bottom, closer to the actual clips/holes.
Quote:
Originally Posted by ichitaka05
This is freaking awesome read!!! Keep up the great work!
|
Thanks!! It's been fun
