Quote:
Originally Posted by KoolBRZ
Can you use the PI thresholds now? If not, cells below .35% and 5000 rpm will be the same as zero %. I also wonder if there are any PI multipliers in effect, because that would cause the cells with .703 to exceed .75 and then those cells are the same as 100%. However, I don't see how running your PI table will hurt.
Because of the way my AT trans shifts in response to throttle input, this is one table that should be different between MT and AT tunes. I'll try it with the thresholds bypassed over .5 load instead of 1.5, so that the cells below 5000 and .35% will have some effect. Then I will compare it to my other tunes and let you know.
|
Sorry I didnt pay too much attention to thresholds but if you can change the thresholds to get these ratios that will be cool. As I said before going 100% DI at wot requires you to add more spark in those regions where I took away from PFI and added DI