Quote:
Originally Posted by thambu19
I mentioned before that if the Slave cylinder plunger isn't acting on the same place as the pivot point it can cause the fork to acutate in a slightly crooked manner applying more force on one arm of the the fork than the other.
Is there an adjustment/slack where the slave cylinder mounts where we can adjust the position by a mm or so to make sure the point of contact of the slave cyl plunger is right in the middle of the fork?
|
I just installed a new slave cylinder this past weekend and I don't believe you can even adjust the angle of the slave at all. There are two bolts that force you to line it up perfectly.