[DC2R]

Originally Posted by k0tkmnd

I bought one of the customsubenclosure boxes recently. Nice build quality but no way to secure it. Vendor recommended velcro or screws. Haven't had alot of luck with the velcro so far. The velcro just won't stay stuck, though I haven't resorted to a liquid adhesive to adhere patches to the box and interior panel yet. Box also doesn't sit flat on the floor so I'm using a roll of tape under the front ring to prop it up snug into the corner. With the flexibility of the interior panel, I'm not so sure about leaving it secured purely to that anyway.

Was contemplating using the existing body clip holes behind the wheel well that the box snugs into. Secure in two bolts sticking out as studs, put matching holes in the box and essentially bolt the box to the wheel well. Not sure if two would be sufficient, but the whole thing weighs so little even with a sub that I don't think I should worry too much. Would be an absolute pita to remove though.

Opinions/ideas?

Does sound very nice, pretty much what I was hoping for, not too boomy or punchy. Running a pioneer ts-w260d4 off an alpine mrx-v70.

Sent from my Note 2 using Tapatalk

Site is down. What is internal volume?