Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

vidarw · 10-25-2015, 06:23 PM

Hi,
I've got a EU GT86 with Toyota Touch&Go Navigation.

Would love to get some help with video-in on the AUX.
I've connected pin 25 (aux detection) to chassis ground and VTR mode is enabled. I do however have problems getting video to work. The video screen is just blue. showing no real signal.

What is the correct way to connect the Video In cable. Currently I have the positive pole/center at pin 13 and ground at pin 27. I have tested multiple combinations (with pin 13 signal, pin 14 as video ground and vice versa).

Have tried with a Raspberry Pi in both forced NTSC and forced PAL mode.

Any suggestions? What is the correct video pins supposed to be?

10-25-2015, 06:23 PM	#1
vidarw Junior Member Join Date: Oct 2015 Drives: GT86 High Location: Bergen, Norway Posts: 9 Thanks: 0 Thanked 7 Times in 3 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	GT86 AUX/VTR Video In Hi, I've got a EU GT86 with Toyota Touch&Go Navigation. Would love to get some help with video-in on the AUX. I've connected pin 25 (aux detection) to chassis ground and VTR mode is enabled. I do however have problems getting video to work. The video screen is just blue. showing no real signal. What is the correct way to connect the Video In cable. Currently I have the positive pole/center at pin 13 and ground at pin 27. I have tested multiple combinations (with pin 13 signal, pin 14 as video ground and vice versa). Have tried with a Raspberry Pi in both forced NTSC and forced PAL mode. Any suggestions? What is the correct video pins supposed to be?