Quote:
Originally Posted by wutsaiu
Simple steel drive shaft I had left over from previous project, just had to get it shortened.
Canbus solution is nothing special, just buy the Arduino and Canbus add on board. Costs like $75.00 for the parts. Requires a bit of soldering then upload the code. I have no problem sharing my code and I hope to improve it soon and get more things working.
|
You are my hero. Well done sir.
I would be super thrilled if you were willing to toss your code into the CAN BUS DIY thread.
I'm super jealous of the last two threads here.. My project has been held up; I've been on the road with job stuff for months now, and I'm in the middle of moving again. (originally going overseas but not anymore)