View Single Post
Old 09-13-2015, 04:32 PM   #3
ShibaYuki
Senior Member
 
Join Date: Dec 2013
Drives: 2013 WRB Subaru BRZ Sport-tech
Location: Toronto, Canada
Posts: 153
Thanks: 29
Thanked 21 Times in 14 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Garage
Quote:
Originally Posted by wparsons View Post
Are you already running the UEL tune?

P0171 is too lean on bank 1
P2097 is too rich on bank 1
P219A is a/f ratio imbalance on bank 1

These cars only have one bank for O2 sensors, so you can ignore the bank 1 part. If this wasn't happening before the header, it's pretty safe to rule out the MAF.

Are you getting all three codes back, or just the lean code?

Did you install the header, or have a shop do it? If it was done at a shop, I'd go back and ask them to check for leaks and to make sure both O2 sensors are plugged in and in the right locations.
Thanks for the response. I'm on UEL stg2 91oct OFT v2.068. And it only started after I took my car to nextmod to install it for me. I'm also now getting P0137. It's saying rear O2 sensor low voltage. Is it safe to drive the car and just erase the code for a bit? As well as is it normal to smell gas on full out catless exhaust?
ShibaYuki is offline   Reply With Quote