Quote:
Originally Posted by Bach415
I see. Let me know if you need any help in terms of dimensions for the Type-80.
|
I may, though FT-86 SpeedFactory is suppose to be sending me their used one for testing
. That will ultimately be what gets it done I think.
Alright, everyone looking for the alternate design, I have an update for you. I went and got one from the shop late Friday so I could test fit it over the weekend and take some pictures. Below are the photos detailing the revisions from the previous production run so everyone is on the same page
.
First, a small teaser picture of the new design.
Next, a small update to the hardware. I only heard one complaint about the nylon spacers being too weak; however, I took this for what it was and sourced some thicker units (new units on left, old units on right). Why nylon? They come in black already and they are extremely lightweight. Good luck squeezing these any!
Like previously stated, we added a full 1/4" of play to the front mounts. This should clear up anyone with OEM exhaust fitment issues I hope. New in foreground, old in background.
Finally, we reduced the front lip to make room for an even larger variety of exhausts. I noticed the need for this with the Greddy Evo IV install I did personally. This should help with a few exhausts. New on left, old on right.
Otherwise, the unit remains unchanged. The unit has the same AOA, same rear lip, same mounting points, etc. I will do my best to get some installed pictures up soon. The latest production run of aggressive units will have the same revisions as well. Most of them unnecessary but always striving to make a better product
.