BaysonR TRD Side Skirt Installation:
SCREWS
6 Brackets (goes with the little (12?) golden screws) - Underneath of the car
4 Gold Screws Holders - Front of the car
4 Silver Screws Holders - Back of the car
8 Black Screws - For the front and rear of the sideskirts. They go into the the gold and silver holders.
REAR SIDE SKIRTS
No holes are being drilled. The silver clamps allow you to clamp the sides of the car to prevent drilling. The rear side skirt use the
2 silver screw holders and
2 black screws. Clamp the silver screw holders in between the rear end of the car and align it with the side skirts.
FRONT SIDE SKIRTS
Same thing just use the gold screw holders. Remove the bottom two push pins. Tug in the clamps; align it with the side skirts and screw in.
BOTTOM OF THE SIDE SKIRTS.
This is where you make the side skirts fit in super snug. Use the tiny gold screws to attach these brackets into the side skirts. Once you've attached these brackets, force the brackets to fit into a metal lining that's underneath your car. The lining should already have predrilled holes for you to screw in. All the screws needed in this step are the tiny gold pieces.
Remember their are two screws used for each attached bracket. One that goes to the bracket itself and the other on the metal lining.
PM me if you have any questions.