Quote:
Originally Posted by mit_peid
Received my set of Flex Zs earlier this week. If the green paint is indicative of their quality, these should be much better than the Konis (which arrived with flaked yellow paint) I currently have on my car. Hope to install this weekend. These are my first set of height adjustable coilovers ever. I need to figure out how to adjust ride height. Anybody know what's the drop if I just don't touch them at all? I'm just looking for a drop in the 1-1.2" range.
Attachment 117790 |
It's recommended you adjust them to spec and tighten down everything. My fronts were a bit out of spec and needed more spring pre-load. Rears were pretty close to spec. Make sure you tighten the spring pre-load collars good before you put them on cause it's going to be much harder after they're on, especially in the rear.
On a separate note I tried 6 clicks at first and felt that was worse than stock, cinched up to 4 all around and it feels better than stock now.
I couldn't figure out if the rears were matched to a left or right but did notice one rear has a small groove in the edge of the top plate. I assumed this was for the left rear.