Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

stokeless · 08-11-2015, 12:52 PM

I followed these steps when loading my tune, I didn't have an issue with the dead spots.
http://www.ft86club.com/forums/showthread.php?t=71157

My Throttle Pedal has dead spot - car sluggish after Flashing Tune

To minimize any issues and speed up learning after a Flash or Reset

Turn ignition fully off after a flash or reset
Turn ignition fully ON, do not start car, do not touch throttle, leave for 20 sec this will allow ECU to perform its diagnostics and calibrations on cam position and throttle position sensors
Turn off ignition
Turn on ignition leave for 20 sec then start car do not touch throttle
Let car idle for at least a minute and wait till it settles at the normal idle of about 750 RPM, again do not touch throttle.
After normal idle is achieved then drive car.

08-11-2015, 12:52 PM	#3873
stokeless Senior Member Join Date: Feb 2015 Drives: 2020 BRZ PP Silver Location: MN Posts: 110 Thanks: 41 Thanked 46 Times in 32 Posts Mentioned: 2 Post(s) Tagged: 1 Thread(s)	I followed these steps when loading my tune, I didn't have an issue with the dead spots. http://www.ft86club.com/forums/showthread.php?t=71157 My Throttle Pedal has dead spot - car sluggish after Flashing Tune To minimize any issues and speed up learning after a Flash or Reset Turn ignition fully off after a flash or reset Turn ignition fully ON, do not start car, do not touch throttle, leave for 20 sec this will allow ECU to perform its diagnostics and calibrations on cam position and throttle position sensors Turn off ignition Turn on ignition leave for 20 sec then start car do not touch throttle Let car idle for at least a minute and wait till it settles at the normal idle of about 750 RPM, again do not touch throttle. After normal idle is achieved then drive car.