Quote:
Originally Posted by steve99
Yes that transition area between open/closed loop always presents some issues. yes just try manually adjusting those values
just keep the maf curve smooth
look at the open loop data and the closed loop data in that area and come to a compromise in the middle is usually a good starting point
|
Quote:
Originally Posted by Wayno
For 3.2V, you should scale with low load open loop. Then attempt to lean it up with load limits for WOT if required. Otherwise you'll run lean at low load.
|
Thank you both for answering.
Hmm. Do you have any hints where I can gather further information about load limits?