|
I wanted to share some preliminary photo of a potential Aim MXG in place of the OEM cluster.
The Aim MXG should fit almost perfectly in place of the OEM cluster circuit board.
The OEM circuit board container is thicker than the MXG so thickness should be ok.
The MXG is like 1/4 in taller than the cluster but with the bottom part sticking out it should only be a small piece of the bezel that should not ve in direct view. (see the part circle in red in my photo)
Now I need to find out if there is enough space behind to have all the Aim MXG wiring sticking out. It seems like its protruding quite a bit.
Anybody has a photo of these wires behind the MXG ? ideally with a ruler to get exact sizes ?
PS: this stealth installation would require to buy the extra module that relocate the Aim cluster button somewhere else. An additional expense but I think this could end up looking really nicely integrated.
|