Quote:
Originally Posted by snidd111
@ Teclis
check this out for power: http://theattack.rallysportdirect.co...r-ssubaru-brz/
That's what I did and it's so much easier than tapping over at the ECU like a different wiring diagram I found suggested. I had to run the cables around 6" since they were mounted over the defroster vent rather than the width of the car.
Also, instead of using a galley plug and disconnecting the stock pressure sensor, I went with a Mishimoto sandwich plate. It was on Amazon for less than $30. My goal was to keep things all together. |
Thanks man! I'll check that out now!
And I was thinking about using the relocating kit to the gally plug and connect the pressure sensor to that, so I'll keep stock pressure sensor too.. and then have the temp sensor connected to the mishimoto oil cooler housing, after that got 2 1/8 npt spots to put sensors
But did you connect both sensors to that housing? any adapters needed?
What gauge are you using?
